1. When the Climbing Stick falls into the water or is wet, please pull it out and dry it.
2. In order to prolong the service life of the climbing stick, please take it apart after long-term use or after going down the mountain, wipe it and put it away.
3. If a certain part of the mountaineering stick is rusty, a very small amount of rust remover can be used to deal with the wear and rust on the surface, but before use, all the grease on the surface must be removed. The cup will affect the adjustment and locking function of the mountaineering stick. In addition, fine sanding paper can also be used to remove the rust on the surface, so as to keep the locking function of the Climbing Stick unaffected. The Climbing Stick locked by rotation may block the grommet for locking due to the falling of the rust powder of the support rod, so the rust in the grommet must be removed during maintenance, especially before they are combined for use, it must be sure that it is very clean and does not contain any rust and grease.
4. The locking system of the aluminum alloy mountaineering stick can not be pulled out. You can tap the locked part gently or wet the mountaineering stick to reduce some friction, and then you can loosen the mountaineering stick smoothly. After unscrewing, be sure to stand the opening downward, let the water inside flow out slowly, and dry the climbing sticks separately for storage.
5. When the locked climbing stick is rotated, the grommet in the support rod will rotate with the support rod and cannot be locked, the support rod can be disassembled, and then the grommet can be completely cleaned before installation. If it cannot be locked, disassemble the support rod, turn the thinner support rod into the grommet to open the grommet, and then directly insert it into the thicker support rod, adjust it to the desired length, and then lock it.
